Check Before Riding - JDbug Pro 1 Owner's Manual

WARNING:
！
Failure to properly engage the spring-loaded buttons may cause the handlebars to dislodge while
riding and may cause you to lose control and fall. When correctly engaged the handlebars will not
rotate nor will they move sideways. Note that when properly engaged, the spring-loaded buttons
are clearly visible in the holes on the T-tube.
from the locked position and allow you to pivot it to the upright position
WARNING:
！
Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter. Make
sure others are standing clear.
D. To adjust the height of the handlebars, unlock the steering tube by
pulling outward on the quick-release lever. Slider the T-tube to the desired
position and secure by pushing inward on the quick release clamp.
WARNING:
！
Failure to properly engage the quick-release clamp may cause the T-tube to telescope up or down
while riding which may cause you to lose control and fall. With the quick-release properly
adjusted and engaged, the handlebars will not move up or down.
E. the tension of the quick-release clamping mechanism can be adjusted by
tightening or loosening the Allen bolt. Be careful not to over-tighten. You
should always be able to open and close the quick-release lever by hand and the
t-tube should telescope freely with the quick-release open.

3. Check Before Riding

B. To release the folding mechanism, grasp the T-tube with one hand
between the collar clamp and the quick-release clamp and, with the
other hand, pull up the joint lever up to release the steering column
C. The joint lever is spring-loaded and will automatically lock in the
upright position when fully upright.