~iPoMan II 1200 Quick Installation Guide~ Getting Started The following procedure describes the basic steps needed to set up the iPoMan II 1200: 1. To set the mode of operation for the iPoMan II 1200 (S1 =off, S2= off). To set up the hardware, connect power to the power inlet and output devices to the power outlets.
Page 3
~iPoMan II 1200 Quick Installation Guide~ 4. Select the System Group submenu under the iPoMan II 1200 Configuration to set up the IP Address, Gateway Address, Network Mask and the System Date/Time. This IP address will be used while accessing the web interface to configure the iPoMan II 1200 parameters.
Page 4
~iPoMan II 1200 Quick Installation Guide~ Connecting EMD An Environmental Monitored Device (EMD) that is connected to sensors for detecting temperature, humidity, water level, and so on can be connected to the iPoMan II 1200 with the console port. The EMD can also be connected to alarms or indicators and controlled through the iPoMan II 1200.