Advertisement
Power
DC 14.5V
Working electric current
200mA
Camera lens
1/3 CCD 72 degree ken
Illumination
0.05 LUX
Communication duration
120s
Communication method
Duplex communication type
Working temperature
-20 +55 C
IP rating
55
Specifications of 50/561 series code access
1. The original factory defaulted programming
password is 1234.
2. Input a 4 digits password to have the door
striked or the lock unlocked.
Change the master code
1. Shut down the power of the unit and keep pressing the button
2. Switch on the power pressing the button
give a long continuous tone.
3. When the tone stoped, another sounds will be heard and input your
new 4 digits programmers codes.
-7-
o
.
down, the unit will then
Entering programming mode
1. Press the button
plus your 4 digits master codes
2. Your are successfully enter the programming mode when three
sounds is heard and the LED is flashing.
3. Press the button
to quit.
Set the unlocking time
Factory default setting is 5 seconds.
1. Enter programming mode.
2. Enter 00 (this is a special code group), two "Di Di" sounds as
reminder.
3. Enter a desired lock/delay operation time in a two digits fomat
(01 to 99 seconds).
4. Press the button
to quit.
Add user codes
1. Enter programming mode.
2. It is available for 40 groups code. 01 to 40 is the group number,
which should be input in front of the 4 digits codes from 31 to 40
group codes, input once 4 digits codes to open the door for a long
time until twice the same code to have it closed.
3. Input 4 digits codes, a two sounds is heard, it is unsuccessful and
indicating the code is existent at somewhere, if a three sounds is
heard, it is successfully set.
4. Press the button
to quit.
.
.
.
.
.
.
.
.
.
.
-8-
Advertisement
