Crest Audio X-VCA Owner's Manual page 37

Bus assignment features
Balance control
The Balance control adjusts the Stereo balance for the Left/Right assignment
and Group assignment sections when the BAL ON button is depressed
balance on—groups—
The left and right signals are summed as mono before being routed to the L-
R and Group assignments.
The left and right signals are routed to L-R and Group assignment section in
odd/even pairs.
GROUP
and assignment switches 2, 4, 6 and 8 carry the right input-signal.The pro-
GROUP
portion of left vs. right can be adjusted by the
group 1–8 assignment
The input channel's post-fader signal is assigned to the corresponding
bus(es). see—balance on—groups
input fader
The input fader is the primary level control for signals being sent to any of the
consoles mix buses.The only signals not affected are
pre-fader. The fader offers greater than 80db of attenuation and up to 10db of
boost. Normal operation is between -10 and 0.
solo
Pressing this switch will include (illuminated) or exclude (not-illuminated) the
input channel from the consoles
see—master module, solo control system
BAL ON
assignment switches 1, 3, 5 and 7 carry the left input-signal
BALANCE
system.The channel is Solo'd in stereo.
SOLO
stereo input module
control.
GROUP
sends selected to be
AUX
2
p. 37