Table of Contents
Advertisement
Netzstecker ziehen
Wassertemperatur mit genau-
b
b
em Thermometer messen
Markierungspfeil (rot)
b
auf die gemessene Wassertemperatur drehen
Einstellskala (blau)
die gewünschte Beckentempe-
ratur einstellen.
Kenndaten (siehe Tabelle Seite 2)
Diese Angaben sind Richtwerte für geschlossene Aqua-
rien bei einer Wassertemperatur bis 26°C.
Garantie: 3 Jahre
Nicht auf Glasschäden, unsachgemäße Behandlung und
Öffnen des Gerätes.
Im Störungsfall bitte an Ihren Fachhändler wenden –
oder www.eheim.de
Thermostatic aquarium heater
IMPORTANT SAFETY
INSTRUCTIONS
WARNING
– To guard against injury, basic safe-
ty precautions should be observed, including the
following.
READ AND FOLLOW ALL
a)
SAFETY INSTRUCTIONS
DANGER
b)
– To avoid possible electric shock,
special care should be taken since water is
employed in the use of aquarium equipment.
For each of the following situations, do not at-
tempt repairs by yourself; return the appliance
to an authorized service facility for service or
discard the appliance.
1) If the appliance falls into the water,
reach for it ! First unplug it and then retrieve it.
If electrical components of the appliance get
wet, unplug the appliance immediately. (Non-
immersible equipment only)
2) If the appliance shows any sign of abnormal
water leakage, immediately unplug it from the
power source. (Immersible equipment only).
3) Carefully examine the appliance after instal-
lation. It should not be plugged in if there is
wa ter on parts not intended to be wet.
4) Do not operate any appliance if it has a dam-
aged cord or plug, or if it is malfunctioning or
has been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug
or receptacle getting wet, position aquarium
stand and tank to one side of a wall-mounted
receptacle to prevent water from dripping onto
the receptacle or plug.
A "drip-loop", shown in the figure "C", should
be arranged by the user for each cord connect-
ing an aquarium appliance to a receptacle. The
"drip-loop" is that part of the cord below the
level of the receptacle, or the connector if an ex-
tension cord is used, to prevent water traveling
along the cord and coming in contact with the
receptacle.
If the plug or socket does get wet,
plug the cord. Disconnect the fuse or circuit
breaker that supplies power to the appliance.
Mit der
b
DON'T
DON'T
un-
Advertisement
Table of Contents
