Earthing Instructions; Installation - Electrolux KOS-1C5K5R User Manual

EARThING INSTRUCTIONS

This appliance must be earthed. In the event of an electrical short circuit, earthing reduces the risk of electric shock by
providing an escape wire for the electric current. This appliance is equipped with a cord having a earthing wire with a
earthing plug. The plug must be plugged into an outlet that is properly installed and earthed.
WARNING:
Improper use of th earthing plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the
earthing instructions are not completely understood, or if doubt exists as to whether the appliance is properly earthed. If it is
necesary to use an extension cord, use only a 3-wire extension cord that has a 3-blade earthing plug, and a 3-slot receptacle
that will accept the plug on the appliance. The marked rating of the extension cord should be equal to or greater than the
electrical rating of the appliance.

INSTALLATION

1. Ventilation
Do not block air vents. If they are blocked during
operation, the oven may overheat and eventually
cause a failure. For proper ventilation, allow above
76mm of space between oven sides, rear and
the minimum height of free space necesary above
the top surface of the oven is 170mm.
2. Steady, flat location
This oven should be set on a steady, flat surface.
For correct operation, the oven must have sufficient
airflow. Do not block air vents as this may cause
overheating. In a freestanding situation allow
adequate ventilation around the microwave from
any overhead, rear and side wall constructions.
Note: Cabinet materials must be suitable to
withstand temperatures up to 90°C.
3. Leave space behind and side
All air vents should be kept a clearance. If all vents
are covered during operation, the oven may
overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference
may result if the oven is located close to a TV,
Radio antenna, feeder and so on. Position the
oven as far from them as possible.
EMS3477X(KOS-1C5K5R)(영)_E-LUX.indd 5
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or splash
when choosing a place to position it, or the
insulation might be adversely affected and
breakdowns occur.
6. Power supply
• Check your locla power source. This oven requires a
current of approximately 15 amperes, 230V 50Hz.
• Power supply cord is about 1.4 meters long.
• The voltage used must be the same as specified on
this oven. Using a higher voltage may result in a fire
or other accident causing oven damage.
Using low voltage will cause slow cooking. We are not
responsible for damage resulting from use of this oven
with a voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or a similarly
qualified persons in order to avoid a hazard.
7. Examine the oven after unpacking for any
damage such as:
A misaligned door, Broken door, A dent in cavity. If
any of the above are visible,
DO NOT INSTALL, and notify dealer immediately.
8. Do not operate the oven if it is colder than
room temperature.
(This may occur during delivery in cold weather.)
Allow the oven to become room temperature
before operating.
5
2014-10-06 오전 11:44:35