Troubleshooting Milk Froth Preparation - Breville CREATISTA PLUS User Manual

Troubleshooting Milk Froth Preparation

Milk steam cycle does not start
Quality of froth not up to standard
Steam is very wet
Milk overflows
Milk temperature is too hot
Milk temperature is not hot enough
Lower Wand alert is displayed
Clean Steam Wand alert is displayed
- Check if the water tank is correctly positioned, if empty, fill with potable water.
- Check steam tip for any blockages and ensure wand is lowered.
- Be sure to use pasteurised whole or semi-skimmed milk at refrigerated
temperature (about 4-6 °C / 39-43 F). For a better result, the milk must be
newly opened.
- Check the milk froth setting.
- Use cold, potable water. Do not use highly filtered, demineralised or distilled
water.
- Fill jug with appropriate milk volume.
- Minimum fill level as marked on the inside & outside of the jug.
- Maximum fill level as marked on the inside & outside of the jug.
- Be sure to use the Breville milk jug provided.
- Check the milk jug is positioned correctly on the milk jug temperature sensor.
- Check the temperture sensor in the drip tray is clean.
- Preheat cup.
- Use the Breville milk jug provided.
- Check the milk jug is positioned on the milk jug temperature sensor.
- Ensure the steam wand is lowered.
- Clean the Steam Wand.
- Use the Breville milk jug provided.
- Clean both the milk jug and steam wand after each use.
- Clean the steam wand. Navigate to Maintenance menu.
- Select Clean Steam Wand and follow the on-screen prompts.
- To stop overflow, either reduce the initial volume of milk and/or reduce the froth
level. This varies depending on milk type.
- Decrease the milk temperature setting.
- Increase the milk temperature setting.
- Check the steam tip for blockages.
- Navigate to Maintenance menu. Select Clean Steam Wand and follow the
on-screen prompts.
EN
28