Advertisement
Installing
or
removing drill bit
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go. Hold
the ring firmly and turn the sleeve clock-
wise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button. To stop
the tool from the locked position, pull the
trigger fully, then release it.
Switch
trigger
Lock button
6
Advertisement
