Page 1
Drill MODEL 6407 MODEL 6408 6407 6408 004611 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
8JD, ENGLAND tic. Responsible manufacturer: Power supply Makita Corporation Anjo Aichi Japan The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They...
GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.
20. Maintain power tools. Check for misalignment or ditions and the work to be performed. Use of the binding of moving parts, breakage of parts and power tool for operations different from those any other condition that may affect the power intended could result in a hazardous situation.
Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing drill bit For Model 6407 004641 To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand.
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspec- tion and replacement, any other maintenance or adjustment should be per- formed by Makita Authorized Service Centers, always using Makita replacement parts.
Page 7
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
Page 8
Makita Corporation Anjo, Aichi, Japan 884078C225...