Roper B9758B0 Use And Care Manual page 12

TO SET A CLEAN CYCLE TO STOP A CLEAN CYCLE:
The sellcleantng cycle IS preprogrammed lor 3% hours. You can also
set the electronic ranqe control lor a delayed slarl of the clean cycle
To self-clean:
1. Push the CLEAN button.
2. Turn SET knob tn the clcxkwlse drrectlon about % turn.
The word CLEAN WIII be on In the display.
NOTE: You can find out when the clean cycle WIII be finsihed by
pushing the STOP TIME button.
To use delayed self-clean:
_-
1. Push STOP TIME button
2. Turn SET knob to time of day when you wish cleaning to be com-
pleted (must be more than 3% hours later than current time of
day).
3. Push the CLEAN button.
4. Turn SET knob in the clockwlse dIrectIon about l/z turn.
The words DELAY CLEAN WIII b :' In the display until the clean cycle
starts. After the clean cycle starts e word CLEAN will be on rn the
display.
Note: Dunng a delayed self-clean operation you can find out when the
oven turns on by pushing and holding the CLEAN button.
1. Press the OVEN CANCEL button
2. Wail unlll the oven has cooled below locking temperature and
the word LOCK IS off in the display
You ~111 not be able to open the door unless the oven temperature IS al
a sale level If you cannot open the oven door immediately after the
word LOCK goes off, wall about one minute and try agaln.
WHEN A CLEAN CYCLE IS FINISHED
1. When a clean cycle IS flnlshed the word CLEAN WIII be off in the
display.
2 Walt untrl the oven has cooled below locking temperature and
the word LOCK
IS
off in the display.
You WIII not be able to open the door unless the oven temperature IS at
a sale level. If you cannot open the oven door irnmedtately after the
word LOCK goes off, wall about one minute and try again.
AFTER A CLEAN CYCLE
After a clean cycle, you may notice some white ash in the oven Just
wipe
It up with a damp cloth.
If white spots remain. remove them with a soap-Illled steel wool pad. Be
sure to rinse thoroughly with a vinegar and water mixture. These
deposits are usually a salt residue that can not be removed by the
clean cycle.
II the oven IS not clean after one clean cycle, the cycle may be
repeated.
12