Kärcher VC 6300 Instructions Manual page 13

Low suction power – for laced curtains,
textiles, upholstered furniture, cushions
Medium suction power – for slightly
dirty carpets/ carpeted floors, precious
carpets, bridges and runners
Highest suction power – for hard
floors, very dirty carpets and carpeted
floors
It is advisable to use the Stand-by key
(C) during short breaks in cleaning:
Press the Standby key, the appliance
switches off, the LED on the appliance
glows to indicate the standby mode.
QuickClick attachment
QuickClick Using the attachments
Upholstery nozzle: for cleaning uphol-
stered furniture, mattresses, laced cur-
tains, etc.
Furniture brush, rotating: for cleaning
furniture and delicate objects with care,
dusting books, air vents in the car, etc.
Joint nozzle, detachable: for edges,
joints and heaters
Changing the attachments in the Quick-
Click attachment housing
Hang in the floor nozzle in the park hold-
er on the rear side of the machine and
press it into locking position (see illustra-
tion 4)
Illustration
Push the dead button at the handle and
remove the telescopic suction pipe.
Illustration
Open the attachment housing cover.
Illustration
Insert the handle in the desired accesso-
ry until the stop. It then gets locked. Then
tilt it downwards and pull it out.
Illustration
To store, put the attachment using the
handle into the attachment housing and
click it up into place. Remove the handle.
Suction using accessories
Press the Stand-by key again to resume
work.
Note: After pressing the stand-by key,
the vacuum cleaner runs at the vacuum
setting that had been set earlier.
Important notice! The appliance will shut-
down automatically, if there is danger of
overheating. Turn the appliance off and pull
the power plug. Make sure, that the nozzle,
the suction pipe or the tube is not clogged,
failing all the above the filter must be
changed. After the elimination of the interfer-
ence let the appliance cool down for a mini-
mum of 1 hour, before using it again.
Notice: You also can remove the attach-
ment manually and put it on top of the
handle. In order to release the attach-
ment, push the dead button on the han-
dle.
Notice: All steps stated above can also
be done when the telescopic suction
pipe is connected. Hang the floor nozzle
on the backside of the appliance into the
parking holder, and push into the pause
position. Pull the telescopic suction pipe
straight up.
ComfoGlide nozzle
Illustration
Carpets and carpeted floors:
Select the following switch settings:
Illustration
Hard surfaces:
Select the following switch settings:
9
English