Pack Contents; Operation; Maintaining Water Levels - Buffalo L310 Instruction Manual

Telephone Helpline: 0845 146 2887 (United Kingdom)

Pack Contents

The following is included:
• BUFFALO Bains Marie
• Pans 2 x 1/3 and 2 x 1/6 (S007/S047 only)
• Support bars (S007/S047 only)
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

Power Switch
Connect the appliance to the power supply.
1.
Fill the tank with water to a level between the 'MIN' and 'MAX' marks on the inside of the tank.
2.
Note: BUFFALO recommend that fresh water be used each time the appliance is used.
Switch the power switch to the On position [I]. The red power indicator light will turn on.
3.
Turn the thermostat to the highest setting (90°C) to heat-up the appliance.
4.
Once the appliance has heated the water the power indicator light turns Off.
5.
Reduce the heat setting. An operating temperature of 75°C - 80°C is sufficient.
6.
WARNING: Do not allow the water to drop below the 'MIN' level during operation.
Severe damage to the heating element could result.

Maintaining Water Levels

It is important to regularly check the water level in the Bains Marie tank.
• Always keep the water level above the 'MIN' mark on the inside of the tank during operation.
• Damage to the heating element can occur if the tank boils dry and the element may have to be
replaced.
• This is not covered by the BUFFALO warranty.
• 6 litre pots x 2 (S077 only)
• Instruction manual
Power Indicator Light
70
Thermostat Dial
UK
2