Functions - Belling FW914 Whi User Manual

Simple everyday use
Introduction of control panel
•
Sports Wear
You can select this procedure to wash the
activewear.
•
Jeans
This program is specially designed for washing
jeans.
•
Hand Wash
As for few light dirty clothes, the default
temperature of washing is cold.
•
My Wash
Press Spin 3sec. for my cycle to memory the
procedure. The default my cycle is cotton.
Auxiliary function
These functions can be used based on
main program, you can press these
functions after you chose the main
program.
Note: you can't use these functions after
the main program started.
•
Prewash
The indicator of prewash will light up on the
display.
The Prewash function can get an extra wash
before main wash.
•
Time Saver
The function can decrease the washing time.
•
Extra Rinse
The laundry will undergo extra rinse once after
you select it.
•
Delay
Delay function can be set with this button, the
delaying time is 0-24 H.
Set the Delay function:
1. Select a programme;
2.Press the Delay button to choose the time;
3.Press Start/Pause to commence the delay
operation.
Cancel the Delay function: Press the Delay
button until the display will be 0H.It should be
pressed before starting the program. If the
program already started, should press the
On/Off button.
Notes: If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme and
when the power is restarted, press the
Start/Pause button the left time is continues.
•
Stain
This function can be adjusted depending on the
amount of stains on the clothes to be washed,
this will adjust the wash cycle accordingly.
There are 3 levels that can be selected,
"Light", "Normal" and "Heavy".
13
•
Plus Wash
This function can be used to add any items that have
been missed from the wash load once the wash
cycle has started.
To operate this function please follow the
steps below:
1.Press and hold the "Start/Pause" button
for 3 seconds.
2.Wait for the drum to stop rotating and the door
lock to be released.
3.Open the door and add the garments that
have been missed.
4.Close the door and repress the
"Start/Pause" button.
•
Child Lock
To avoid that the washing procedure cannot operate
normally due to the mis operation by kids during the
washing procedure, you can select this function, In
this case, the other buttons except On/Off button
can not work, at this state ,the machine power off
when press the key on/off. The machine remembers
the program child lock and the program during
powered off when press the key on/off again.
Press Extra Rinse and Pre Wash together 3 seconds
during the running procedure, the buzzer will beep ,
Start/Pause button as well as the rotary switch are
locked. Press the two buttons for 3 seconds together
and buzzer will beep to release to locking. But cut
off the power supply , the kid's protection is also
release to locking. The kid's protection will not be
cancelled after all procedures are completed.
•
Suppression of the acoustic signals
This is an additional buzzer function on your
appliance. After deactivating the buzzer function,
the buzzer will be closed. After starting the machine,
press the "Temp.&Spin" button for 3 seconds and
you will hear a beep, then the buzzer will be closed.
To restart the buzzer function, press the
"Temp.&Spin"button again for 3 seconds. The setting
will be kept until the next reset.
Warning: After deactivating the buzzer function, the
sounds will not be activated any more.
- Bubble Removal Function
Bubble Check Function: Redundant bubbles will
occur when there is excessive detergent, which will
affect wash and rinse effects. The procedure will
check automatically and one bubble removal
procedure will be added automatically to remove
bubbles when excessive bubbles are checked.