Snowrator Operations Page; Operations - L.T. Rich Products Snowrator Zx4 Owner's Manual

Be sure that guides (4) are not damaged to allow the hopper door to slide freely
Check agitator wire on a daily basis. If wire is not present, product will run the risk of
building up prior to reaching hopper door and not spreading evenly.
SECTION 4
4.1

Operations

Upon turning the key on to start the unit, apply full choke. The manual Choke is located
just above the "Fuel Shut Off" on the engine (picture # 1). Push Choke lever away from
the operator and toward the front of the machine. Once the unit is started, push the Choke
lever back toward the operator to shut choke off (picture #2) . Once unit has started,
move the Throttle lever (always turn down Throttle to the lowest position before
starting and before turning off the unit) to a desired position for operations.
Push Joy Sticks forward (equally) to have the unit move straight. Should you want to unit
to back up in the reverse direction, pull back on the Joy Sticks. If a turn is desired, push
opposite Joy Stick of the direction you want the unit to head forward (if wanting to turn
left, push the right lever forward while keeping the left lever slightly back of the right
thus allowing the right tire to turn more than the left. Push more on the left lever if you
desire to turn the unit to the right). Be cautious as turn radiuses change with the speed
you are going and the amount each Joy Stick is positioned forward or backward
positions.
SNOWRATOR OPERATIONS
(picture #1)
Page 12
(picture #2)