Summary of Contents for L.T. Rich Products Snowrator Zx4
- Page 1 OWNERS MANUAL Snowrator Zx4 920 Hendricks Drive Lebanon, IN 46052 (877) 482-2040 www.snowrator.com...
-
Page 3: Table Of Contents
TABLE OF CONTENTS SECTION 1 TO THE OWNER PAGE Read this manual entirely BEFORE operating the Snowrator……………………..…..1 Product / Warranty Registration…………….…………………………………..……...1 L T Rich Products Warranty……………………………………………………………1 Component Manufactures’ Warranties…………………………………………..……..2 Conditions Which Void Warranty……………………………………………….……..2 Warranty Exceptions……………………………………………………………..……..2 Registration Card…………………………………………………………………...….26 SECTION 2 SAFETY INFORMATION PAGE About this manual………………………………………………………………...….2-3 Safety guards and covers……………………………………………………………….3... -
Page 4: Read This Manual Entirely Before Operating The Snowrator
Serial Number: __________________________ L.T. Rich Products, Inc Warranty L.T. Rich Products, Inc warrants its line of equipment to be free of defects in material and factory workmanship for a period of 12 months of purchase. Any exception to this will be explicitly stated in an individual warranty agreement in the operator’s manual of that stated piece of equipment. -
Page 5: Component Manufactures' Warranties
Component Manufactures’ Warranty Some of the component parts of the Snowrator are warranted by their respective manufactures. These parts are: Hydro-Gear Pump Parker Wheel Motors Honda Engine Delevan Liquid Pump The complete manufactures’ warranty information for these components is located in the back of this manual. -
Page 6: Safety Guards And Covers
The illustrations and data used in the manual were current at the time of printing, but the Snowrator may vary slightly due to ongoing engineering changes. L. T. Rich Products, Inc reserves the right to implement engineering and design changes to the Snowrator as may be necessary without prior notification. -
Page 7: Storage Safety Rules
Periodically tighten all nuts, bolts and screws and check that all fasteners are properly installed to ensure that the Snowrator is in safe operating condition. Storage Safety Rules Never store the Snowrator in any area accessible by children. Never store the Snowrator with fuel in the tank inside a building where fumes could reach an open flame or spark. -
Page 8: Hydraulic System Maintenance
Hydraulic System Maintenance Hydro-Gear recommends that the fluid and filter(s) be changed every 500 hours. Use any type of motor oil in a 5W-40 Synthetic or equivalent. Hydraulic system requires 25 micron hydraulic filters (part # 80404) or equivalent to be used. - Page 9 Page 6...
- Page 10 Page 7...
- Page 11 Page 8...
- Page 12 Page 9...
- Page 13 Page 10...
-
Page 14: Traction Unit Maintenance
Clean out tank on daily basis for proper storing. Spreader Maintenance (optional attachment) **USE COMPRESSED AIR (NOT WATER) WHEN CLEANING HOPPER** The Snowrator Zx4 can be equipped with a granular/salt spreader. Recommended maintenance suggestions are as follows: Lubricate (Silicone Spray) Hopper, Deflector and Diffuser cables weekly. -
Page 15: Snowrator Operations Page
Be sure that guides (4) are not damaged to allow the hopper door to slide freely Check agitator wire on a daily basis. If wire is not present, product will run the risk of building up prior to reaching hopper door and not spreading evenly. SECTION 4 SNOWRATOR OPERATIONS Operations... - Page 16 The blade control Joystick Valve has 5 positions of operation. Pulling back on the Joystick Valve will raise the blade to the up position (off the ground for transport of transition). Pulling the Joystick Valve to the left tilts the blade to the left allowing to angle the snow to the left.
-
Page 17: Spraying Operations
SPRAYING OPERATIONS The Snowrator spray system has a liquid storage tank of 20 gallons that can disperse a host of liquid and/or wettable powder. To get maximum life and performance out of the spray system, it is recommended that the tank, nozzles and hoses be flushed of all products after each use. -
Page 18: Spreader Operation
Spreader Operation (Optional) The Snowrator unit has an optional 120 lb. spreader that can be mounted to the machine. This electric hopper motor with the spreader control rate knob allows variable spread widths from 3 to 25 feet. This depends on volume/density, particle size and rate of travel, and weather conditions. -
Page 19: Parts Breakdowns/Part Numbers
SECTION 5 PARTS Part Number / Pictorial (Serial # SR4320-2015-001 to SR3620-2016-085) Page 16... - Page 20 Part Number / Pictorial (Serial # SR3620-2016-086 to current) Page 17...
- Page 21 Spot Spray Gun Part # Description 60040 Spot Spray Gun 60041 Spot Spray Tip ¼” MPT X 3/8” Barb 60029 Page 18...
-
Page 22: Parts List
Parts List Parts List 80202 PUMP ON-OFF SWITCH\nCH-M-58031-01 80210 12 VOLT BATTERY\nSS11U1L CCA350 80215 KEY SWITCH\n4F463 80214-A TACH/HOUR METER 80352-36R JR 36R WHEEL HUB-4 HOLE (r only) 80404 HYDRAULIC FILTER\nAA0513 60010 DIRECTO VALVE AA6B 60012 THROTTLE VALVE\n23520-3/4-PP 60032 GAUGE\nRICH 60-25 60014-A 4.0 GPM PUMP\n5940-111C W/BUTT CONNECTORS 60061... - Page 23 80205-36R JR36R IGNITION HARNESS 86036 36" JR36R HYDRO HOSE 86024 23" JR36R HYDRO HOSE 10058 bulkhead, 1/2" (hole requirement 1 1/4") 60078 1/2 CPVC MIP Adapter EGB716-Black 7/16 Trim Lok Edging 80620 JR36R WHEEL MOTOR RIGHT 80621 JR36R WHEEL MOTOR LEFT 80402-Tandem-REVBB Pump, Axial Tandem Piston, w Aux Pump, 6cc 80403-B...
- Page 24 SWIVEL ONE END, GOODYEAR INSTA GRIP HOSE 86070 RETURN HOSE ASSEMBLY 11" CRIMPED JIC FEMALE SWIVEL BOTH ENDS, GOODYEAR INSTA GRIP HOSE QD-FF-F-04-NPF04-S F. FIRG 14NPT QD-FF-M-04-NPF04-S M. FIRG 14 NPT 80707-plow Plow Spring Century # 614 80213 SWITCH, ON/OFF, WITH LIGHT, SR 90116 LIGHT, LED ROUND, SR 3E4511...
-
Page 25: Troubleshooting
SECTION 6 TROUBLE SHOOTING Troubleshooting Engine: Not starting. There are a few reasons as to why your engine fails to start. If the engine does not turn over, then the battery could be dead, bad connection to the battery wires, key switch may be bad, 30 AMP fuse on the wiring harness (orange wire) may be blown or the starter solenoid may be bad (you will hear the starter solenoid trying to click on, but nothing is happening). - Page 26 Granular: There are numerous potential challenges that can happen on the granular side due to the amount of use this portion of the unit sees. If product is not spreading evenly or consistently, then look for a few things with your hopper impeller or hopper diffuser.
-
Page 27: Wiring Harness Schematics
Honda Engine Wiring Harness Schematics Page 24... - Page 28 Page 25...
-
Page 29: Registration Card
L. T. Rich Products Inc Warranty Registration Card Serial #: Company Name: Company Address: City / State: Company Phone: Company Fax: Company Contact: Company Email: *Please circle what most accurately describes your business* Commercial Sports Complex School Municipal Cemetery Home Owner Other Dealer Name: Dealer Address:... -
Page 30: Maintenance Chart
Maintenance Chart Daily Weekly Bi-Weekly Monthly Yearly Hours SERVICE ACTION(S) Tire Pressure (18 PSI) Rim Nut Torque (75lbs) Hub Castle Nut (check cotter pin) Engine Oil (check) Engine Oil Change 50 hrs replace Engine Air Filter Check (change if needed) Engine Air Pre-Filter Check 25 hrs (change if needed)