Table of Contents
Advertisement
UNPACKING AND SETUP
•
Carefully remove the unit from the display carton and remove all
packing material from the unit.
•
Unwind the AC power cord and extend it to its full length.
•
Place the unit on a stable, level surface, close to an AC outlet, out
of direct sunlight, and away from sources of excess heat, dust,
moisture, humidity, or strong magnetic fields.
•
Raise the lid to expose the phonograph. The phonograph has
been secured for shipment with a transit screw. Use a coin or
screwdriver to TURN THE TRANSIT SCREW CLOCKWISE. This will
allow the turntable to "float" and turn freely.
•
Remove the plastic stylus cover from the phonograph stylus by
sliding it in the direction of the arrow.
•
Discard the stylus cover.
•
Remove the twist-tie that was used to secure the tone arm
during shipment.
•
Release the tone arm lock lever.
•
Connect the AC adapter to the power outlet.
RAISING AND LOWERING THE LID
IMPORTANT:
To open the lid, raise it as far as it will go until the lid support bracket "locks" in the open position. To close
the lid, lift it upward slightly and pull the bracket gently towards you until the bracket "unlocks", and then
gently lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED. ALWAYS RAISE THE LID TO
RELEASE THE LID SUPPORT BRACKET.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber "feet" to prevent the product from moving when you operate
the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid
leaving any marks or stains on your furniture. However, certain types of oil based furniture polishes, wood
preservatives, or cleaning sprays may cause the rubber "feet" to soften, and leave marks or a rubber residue
on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small
self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and
apply these pads to the bottom of the rubber "feet" before you place the product on fine wooden furniture.
PREPARATION FOR USE
- 8 -
Transit Screw
Tone Arm
Lock Lever
Stylus Cover
Hide quick links:
Advertisement
Table of Contents
