4 Use Your Tv; Switching On Your Tv And Putting It In Standby Mode; Adjusting Volume; Switching Channels - Philips 40PFL4709C User Manual

4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
• Press . on the side panel or the Remote Control.
Note(s)
• Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low Standby power
consumption.
Adjusting Volume
To decrease or increase Volume
Press VOL + / − on the Remote Control or VOL ◄/► on the side
•
panel.
VOL ◄ (–) : Volume Down
VOL ► (+) : Volume Up
To mute or unmute sound
• Press (MUTE) on the Remote Control to mute the sound.
(MUTE) again or VOL + / − to recover the original sound.
• Press
Switching Channels
To select Channels by using CH +/− or CH ▲/▼
• Press CH ▲/▼ on the side panel or press CH +/− on the Remote
Control.
To select Channels by using the NUMBER buttons
– When selecting the channel 123
(PREV.CH) to return to the previously viewed channel.
Press
To change broadcast signals
• Press DTV / ATV on the Remote Control while watching a
program.
Note(s)
• To select the non-memorized channels, use the NUMBER buttons.
• C hannel not available or No Signal will appear on the TV screen after the subchannel
broadcast is over.
• Audio only message will appear on the TV screen, when you receive only sound signal.
16
English
Continued on next page.