Hot Surfaces - SEVERIN FR 2432 Instructions For Use Manual

GB
• The appliance must only be connected to the mains if the voltage marked on
the rating label corresponds to the supply voltage.
• Do not kink or pinch the power cord. Keep both the cord and the appliance
itself well away from heat sources (eg hot-plates, gas fl ames).
• When removing the plug from the wall socket, never pull on the power cord;
always grip the plug itself. Do not carry the unit by its power cord.
• Do not immerse the appliance in water or any other liquid, do not clean it
under running water and do not put it in a dishwasher.
• Do not touch the plug with wet hands.
• Do not operate the unit outdoors.
• As long as it is connected to the mains, a current is present inside the unit,
even if it is switched off. Always remove the plug from the wall socket after
use.
• In the case of an emergency or malfunction, disconnect the appliance from the
mains immediately. Ensure, therefore, that the plug the appliance is connected
to is accessible and can be removed from the wall socket at any time.
• Always remove the plug from the wall socket before any cleaning or
maintenance work is carried out.
• Do not insert any objects into the openings in the housing (ventilation slots).
• Do not attempt to open or dismantle the unit, and do not attempt to make any
technical modifi cation.

1.5 Hot surfaces

The unit heats up on the inside and there are ventilation slots at the rear,
allowing hot air to escape and heating up the area around the ventilation slots.
The ventilation slots are marked with a warning label ‚Hot surfaces' as shown in
chapter 2 - Technical specifi cations on page 21, which draws attention to the risk
of scalding.
• Do not touch the housing area around the ventilation slots during or
immediately after operation.
18