SAT>IP (REF. 5400)
3. How to set up the 5400?
Minimal system requirements
The WebGUI is supported by the following web browsers
(and newer versions of these browsers):
Chrome 4
Safari 3.1
Firefox 3.6
Explorer 8
Opera 10.6
When using a different browser, we cannot guarantee a correct functioning of the interface.
Starting up the device
When first connecting the device, be sure to follow this procedure!
Power up the device in a rack with your network, using an RJ-45 Ethernet cable. A DHCP-server should
be available. This is for instance available from your (wireless) router.
Wait until the "Device Ready" LED on the 5400 starts blinking!
The module will obtain an IP address from your router. It is important that your PC is NOT set with a
manual IP address to work with the 5400.
Note : the 5400 can also work with static IP-addresses, if required.
How to set your PC to obtain an automatic IP address is explained in the following procedure (for
®
Microsoft Windows 7
)
Navigate to the Control Panel:
Start Control Panel Network & sharing Center Change adaptor Settings
7