Configuration; Ip Multiswitch; Headend Configuration - Johansson 5400 User Manual

SAT>IP (REF. 5400)

Configuration

1. IP multiswitch


The installation is very simple. Nearly no configuration is needed, except the IP address (if needed)
 When using the 5400 as an IP Multiswitch, all satellite channels from the LNB are available at the
customer TV client device.
 Each 5400 allows up to 32 users to be connected simultaneous
 Each channel is sent in unicast mode.

Connect the 5400 to your network via the IP port and make sure a DHCP server is running on
the same network (each 5400 will get IP addresses from this DHCP server).

Connect your TV client device (smartphones, tablets, Smart TV, ...) to the same network. Both
wired and wireless (WiFi) are possible.

Make sure your TV client device supports the Sat>IP protocol. Some TVs support this protocol,
others will need an app. In case of tablets and smartphones, you need to install the same
Sat>IP app, like legato, Tivizen or others.

The desired app can be found on http://www.satip.info/products/software

Start the Sat>IP app on your client device and follow the instructions. The app should recognize
the 5400 as a Sat>IP server. Basically, you will need to choose the correct LNB (Astra 19°E,
Astra 23°E, Hotbird 13°E, ...) before watching TV.

Start the Sat>IP app and follow the instructions of the app :
Select the device in "settings"
o
o
Select your country and the satellite to which the product is connected
o
Scan the selected satellite (This can take 15min)
A faster way is that the channel list can be downloaded if you have internet connection
(not for all Apps)
o
Select a channel to watch. You can swipe to previous or next channels.

2. Headend configuration


The 5400 can be configured as a Headend, which means the unit is programmed with a
fixed set of channels. The end consumer can only choose between these channels and not
all channels available on the satellite.
 A limited number of selected satellite channels are available (per device: 32ch)
 The system can be used by an unlimited number of users
 The headend streams all channels in multicast: Typ 239.x.x.x
10