Table of Contents
Advertisement
Specifications
Video System:
A/V Switching:
Power:
Aux Audio Outputs:
Current Consumption (stand-by mode):
Current Consumption (on, but no VCP):
Current Consumption (with one VCP on):
Audio Noise Floor (30KHz BW):
THD+N @ -10dBV, 1KHz (30KHz BW):
Cross talk @ 1KHz:
Maximum Input Level, Audio L and R:
Frequency Response, 20Hz – 20KHz:
Frequency Response, 40Hz – 16KHz:
Channel Balance:
Volume Control:
Unit Weight:
Audio Output Min. Load Requirement:
Note: Specifications are subject to change without notice.
Tuner cable ready when used in conjunction with other remote control from accessory list.
Warning
It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a
television viewer or screen that is located in the motor vehicle at any point forward of the back of
the driver' s seat, or that is visible directly or indirectly, to the driver while operating the vehicle.
This product should only be installed to the rear of the back of the driver' s seat where it will not be
visible, directly or indirectly, to the operator of the motor vehicle.
NSTC Analog Composite Video (1V P-P, 75 )
3 channels
10-16 VDC, Negative Ground
Left and Right Variable (800mV max, 8 load min.)
Left and Right Fixed (300mV typical, 600 load min.)
67mA
635mA
1.5A
1.164mV (-58dB re:1V)
0.356%
60dB
800mV
1.5dB
0.5dB
0.5dB, 0.05dB Typical
Dual 64 position log taper w/true 1dB/step accuracy
8.5 lbs.
4
12
Advertisement
Table of Contents
