Panasonic SA-PT460 Service Manual page 31

8.2.4. Service Mode Table 4
Item
Mode Name
DVD DVD Module P.C.B. firmware version is
Module P.C.B. displayed on the FL Display.
firmware The firmware version can be updated
version display using recovery disc.
Note: It is necessary to check for
firmware version before carrying out
the version up using the disc.
Timer 1 check Timer 1 check
Laser operation timer is measured
separately for DVD laser and CD laser.
FL Display sequence:
Display 1
Timer 1 reset Timer 1 reset
Laser operation timer of both DVD
laser and CD laser is reset all at once.
Timer 2 check Timer 2 check
Spindle motor operation timer
Timer 2 reset Timer 2 reset
Spindle motor operation timer
Description
2.
FL Display
Destination
System controller
generation
Region No.: 0-8
(Display 1)
DVD laser usage time
Shown to the above is DVD laser usage
time, and to the below is CD laser usage
time.
Time is shown in 5 digits of decimal notation
in a unit of 10 hours.
"00000" will follow "99999". (DVD laser)
(Display 2)
CD laser usage time
Time is shown in 6 digits of decimal notation
in a unit of 10 hours.
"000000" will follow "999999". (CD laser)
Time is shown in 5 digits of decimal notation
in a unit of 10 hours.
It will clear to "00000" upon reset.
Time is shown in 5 digits of decimal notation in
a unit of 1 hour.
"00000" will follow "99999".
Time is shown in 5 digits of decimal notation in
a unit of 1 hour.
It will be cleared to "00000" upon activating
this.
31
SA-PT460EB / SA-PT460EG
Key Operation
Front Key
In STOP (no disc)
mode, press [STOP]
button on the main unit,
and [8] button on the
remote control unit.
Cancelled automatically
System
5 seconds later.
controller
version
In STOP (no disc) mode,
press [STOP] button on the
main unit, and [
on the remote control unit.
Cancelled automatically
5 seconds later.
Press [FL Display] button for
next page of FL Display.
While displaying Timer 1
data, press [STOP] button
on the main unit, and [
button on the remote control
unit.
Cancelled automatically
5 seconds later
In STOP (no disc) mode,
press [STOP] button on the
main unit, and [
on the remote control unit.
Cancelled automatically
5 seconds later.
While displaying Timer 2
data, press [STOP] button
on the main unit, and [
button on the remote
control unit.
Cancelled automatically
5 seconds later.
] button
]
] button
]