Sensor Pc Board; Handle; Lcd Rear Cover - Toshiba 15DL72 Service Manual

1-4. Sensor PC Board

1. Remove one screw (1) and remove the connector (2)
from the one location, then remove the sensor PC
board (3).
GND lead wire
Sensor
PC board (3)
Fig. 1-1-9
Note:
• When attaching the sensor PC board (3), bundle the
wires with the band (4) and insert into groove then
attach the sensor PC board (3) from the top.
Bundled wires (4)
Place the bundled wires (4)
into this groove and attach the
sensor board (3) on the top.
Fig. 1-1-10
Screws (1)
Connector (2)
Sensor PC board (3)
GND lead wire

1-5. Handle

1. Remove two screws (1), then remove the handle (2).

1-6. LCD Rear Cover

1. Remove the front panel, the LCD panel and the
inverter PC board. (Refer to item 1-1, 1-2 and 1-3.)
2. Remove two screws (1), then remove the support (2).
3. Remove two screws (3) and remove the LCD rear
cover (4) in a vertical position.
Note:
• If not removed when in a vertical position, the hinges
may become deformed.
Screws (3)
GND lead wire
Guide
1-3
Screws (1)
Handle (2)
Fig. 1-1-11
LCD rear cover (4)
Support (2)
Screws (1)
Fig. 1-1-12