Table of Contents
Advertisement
8.
Configure: Device
The Device information is displayed, this is not editable
Firmware Type
this is either VS RPi which is the SC-T25 Firmware, VS RKC which
is the SC-T36 Firmware or VS RePC which is the generic 32-bit X86 release for the
Re-Purpose PC & Laptop Market.
Serial number
is the Hardware Serial number
Firmware version
is displayed in the form of "Kernel Version–Firmware version".
In this example "4.4.7-4.2.5" designates Linux Kernel version 4.4.7 and Firmware
release 4.2.5
MAC
address of the active Network interface
IP address
of the Device
Reset to factory defaults
the installation factory default.
9.
Configure: Displays
The Displays Tab is shown below, in this example a Single display has been
configured, the default is to auto detect and auto configure the display which
normally results in a display configured for the native resolution of the attached
monitor. The connector Output type can be left set at the default Auto or manually
selected from the Drop down list which appears when you click on the down arrow
next to Output Connector. The choices are Auto, HDMI, VGA, DisplayPort, DVI,
Splitter Cable, Built-in Panel or None. The choices on the Single Display
SC-T25 are either Auto or HDMI. If your SC-T25 Monitor only supports DVI, use a
HDMI to DVI cable to connect the Monitor.
The Video mode default is Clone which results in a Mirror Image on the second and
or third displays.
The SC-T25 valid resolutions are shown below, choose a matching resolution from
the drop down Resolution box. (Check that your Monitor actually supports the
resolution that you require).
800 x 600, 1024 x 768, 1280 x 720, 1280 x 960, 1280 x 1024, 1366 x 768,
1440 x 900, 1600 x 1200, 1680 x 1050, 1920 x 1080, 1920 x 1200, 1920 x 1080 is
also known as 1080p this is the default resolution on most Monitors
will erase any configuration changes and reset VTOS to
5
Hide quick links:
Advertisement
Table of Contents
