Panasonic dp-c262 Operating Instructions Manual page 72

Error Messages
Print Parameter Error(006)
Print Parameter Error(101)
Print Parameter Error(104)
Print Parameter Error(106)
Print Parameter Error(107)
Print Parameter Error(108)
Print Parameter Error(109)
Print Parameter Error(119)
72
Possible Cause
Specified the hole punch
position ( Output tab).
However, the Punch Unit is
not installed on the machine.
Specified a Paper
Source unable to print in
Duplex.(Basic Tab)
(Duplex printing is not
possible from the tray
set with A5 in Landscape
format)
Specified a Paper Source
unable to shift sort.
(Basic Tab & Output Tab)
- Only when 1 Bin Finisher
(DA-FS320) is in use.
- It is not possible to shift
sort with B5 in portrait
format.
Specified a wrong Paper
Source when printing a
document with stapling.
Specified a wrong Paper
Source when printing a
document with punching.
Specified a wrong Media
Type when printing a
document with Rotate sorting.
Solution(s)
Verify the settings on the Device tab.
Click the
Auto Configuration
the settings properly when your machine is
connected to the network.
When your machine is connected with USB
cable, set the Punch Unit on the Device tab
correctly.
Specify the tray set with the A5 in portrait format.
Select Automatically Select on the Paper
Source menu.
Specify the tray set with the B5 in Landscape
format.
Click the
Auto Configuration
the settings properly when your machine is
connected to the network.
Verify the settings on the Device tab.
Click the
Auto Configuration
the settings properly when your machine is
connected to the network.
When your machine is connected with USB
cable, set the Finisher on the Device tab
correctly.
Select Automatically Select on the Paper
Source menu.
Verify the settings on the Device tab.
Click the
Auto Configuration
the settings properly when your machine is
connected to the network.
When your machine is connected with USB
cable, set the Punch Unit on the Device tab
correctly.
Select Automatically Select on the Paper
Source menu.
Verify the Media Type setting on your machine.
Select the same media type on the Basic tab as
set on your machine.
button to configure
button to configure
button to configure
button to configure