Suzuki F6A Service Manual page 63

c) Using special tool, drive valve guide out from combus-
tion chamber side to valve spring side.
NOTE:
Do not reuse valve guide once disassembled. Be
sure to use new valve guide (Oversize) when assem-
bling.
NOTE:
Place disassembled parts except valve stem oil seal
and guide in order, so that they can be installed in
their original positions.
24) Remove flywheel; using special tool as shown.
25) Remove alternator bracket.
26) Remove engine mounting brackets from cylinder
block.
27) Remove oil pan.
28) Remove oil pump strainer.
29) Remove connecting rod bearing caps.
30) Install guide hose over threads of rod bolts. This is
to prevent damage to bearing journal and cylinder wall
when removing connecting rods.
31) Decarbon top of cylinder bore, before removing pis-
ton from cylinder.
32) Push piston and connecting rod assembly out
through the top of cylinder bore.
61