Blaster Layout; Power It Up; Sync It Up; Bluetooth Led Solid - NIXON mini blaster User Manual

BLASTER LAYOUT

*show image of product pointing out all of the buttons, connections, and feature locations; side flaps open
exposing side ports; show actual button/port label or symbol, and also the name
Power Button **power symbol
Multi Button **Icon symbol
Previous **previous symbol
Next **next symbol
Volume Up **volume+ symbol
Volume Down **volume-symbol
Charging Port (Micro-USB) **USB
Aux Input (3.5mm stereo) **AUX
Power LED **round illuminated LED symbol half RED/YELLOW
Bluetooth LED **round illuminated LED symbol in BLUE
*both LEDs need two versions, one representing a steady illumination, one flashing
Microphone ** microphone symbol

POWER IT UP

**Power Button + 2 SEC -->> **Power LED solid
Press and hold the Power Button for 2 seconds then release to power ON the Blaster. The Power LED will
illuminate solid.
Press the Power Button again for 2 seconds then release to power OFF.
NOTE: The BLASTER will enter Power Saving Mode to after 5 minutes of no music playback. If the battery is
also low, it will power OFF completely to save the remaining battery.

SYNC IT UP

**Multi Button + 2 SEC -->> **Bluetooth LED flash
Press and hold the Multi Button for 2 seconds then release to enter Bluetooth Pairing Mode. The speaker
will sound a tone and the Bluetooth LED will flash repeatedly.
Now locate the Bluetooth settings on your music device, enable Bluetooth, and then select
"BLASTER" from the list of local Bluetooth devices.

**Bluetooth LED solid

When Bluetooth pairing is successful, the Bluetooth LED will stop flashing and illuminate solid.
NOTE: If your music device supports automatic Bluetooth connection requests, the BLASTER may ask your
music device to connect. Simply confirm by selecting "OK" on your music device.
**AUX (show in symbol/illustration styling)
If your music device does not support Bluetooth connections, use the included AUX Audio Cable to play
music directly to the Blaster.
**show illustration of AUX cable connecting between the BLASTER to a simple iPod-ish device like the nano
(55cm cable, stereo 3.5mm both ends, Stylus-like plugs)
NOTE: When using the AUX input of the Blaster, the Bluetooth audio signal is disconnected, and the
remote control buttons and internal microphone will not function.