Related Manuals for kincrome K13235
Summary of Contents for kincrome K13235
- Page 1 AIR ANGLE U N I Q U E GRINDER 100MM TWIN BEARING SYSTEM UNIQUE ERGONOMIC YEAR COMPOSITE TWIN BEARING GRIP SYSTEM CONSUMPTION WARRANTY K13235 ED1 Sept 15...
-
Page 2: Table Of Contents
7. Air Inlet 8. Trigger 9. Trigger Lock Off 10. Spindle Spanner 11. Pin Wrench 12. Nitto Style Fitting Model No: ........................K13235 Description: ......................Angle Grinder 100mm Free Speed:........................ 10,000RPM Spindle Size: ......................M10x1.5mm Air Inlet: ........................¼” Avg Air Consumption: .................. -
Page 3: General Safety Warnings
AIR ANGLE GRINDER 100MM General Safety Warnings Save all warnings and instructions for future reference. WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in fire and/or serious injury. 1) Work Area a) Keep the work area clean and well lit. - Page 4 AIR ANGLE GRINDER 100MM 4) Service a. Tool service must be performed only by qualified repair personnel. b. When servicing a tool, use only identical replacement parts. Use only authorized parts. c. Use only the lubricants specified by the manufacturer. 5) Additional Safety Warnings a.
-
Page 5: Additional Safety Instructions
AIR ANGLE GRINDER 100MM 7) ADDITIONAL SAFETY INSTRUCTIONS FOR ANGLE GRINDERS a. Use only wheel (disc) types that are recommended for your air tool and the specific guard designed for the selected wheel. Wheels for which the air tool was not designed cannot be adequately guarded and are unsafe. b. - Page 6 Note: If an automatic oiler system is not used, add a 4 to 5 drops Figure A of Kincrome Air Tool Oil to the air inlet before operation. Add 1-2 drops every hour of continual use. Attach an air hose to the compressor’s air outlet. Connect the air hose to the air inlet (7) of the tool. Other components, such as a quick connect fitting and quick connect coupler, will make operation more efficient, but are not required.
-
Page 7: Operation
Disconnect the tool from the air supply holding it so the air inlet (7) faces up. Hold the trigger (8) down and put 4 to 5 drops of Kincrome Air Tool Oil in the air inlet. Holding the trigger down helps circulate oil in the motor. -
Page 8: Parts Breakdown
AIR ANGLE GRINDER 100MM 13) Parts Breakdown Indicates stocked spare parts... - Page 9 AIR ANGLE GRINDER 100MM Notes:...
- Page 10 www.kincrome.com.au...
Need help?
Do you have a question about the K13235 and is the answer not in the manual?
Questions and answers