2
2.2
Checking the setup procedures
This section describes the required procedures for setting up network print-
ing for the selected network print method.
Peer-to-Peer printing
When installing the printer driver on an operating system other than Windows
98 SE or Windows Me, the Peer-to-Peer Utility is not installed.
1
Check that all of the accessories have been included in the package.
("3 Checking the accessories")
2
Connect the network cable. ("4 Connecting the network cable")
3
Specify the IP address, subnet mask, and default gateway settings for
the copier. ("5 Assigning an IP address")
4
Print the configuration page and check the settings. ("6 Printing the
configuration page")
5
Install the printer driver. The Peer-to-Peer utility is installed when you
install the printer driver.
–
For instructions on installing the GDI driver, refer to the user's guide
for the GDI driver provided with the copier. For instructions on in-
stalling the optional PCL driver, refer to the user's guide for the PCL
driver provided with the IC-205.
6
Add a network port to the computer. ("7 Connecting the computer and
copier")
Note
The configuration page cannot be printed for copiers that are not
equipped with the optional Image Controller IC-205 or Fax Kit FK-505.
2-8
Getting ready
NC-502