Installation Diagram - Kelvinator KSE362HPCA Installation Manual

Installation diagram

continuous wiring configuration
150mm
Ø2.5mm
continuous
supply input
All numbered items are supplied with the hot water system. Please refer to the Components list on pages
6 & 7 for details. Items which are not numbered are not supplied and need to be supplied by the installer in
accordance with local plumbing requirements. Installation of this hot water system must be completed by
an authorised and licensed person in accordance with all local regulations, including AS3500 plumbing and
drainage requirements and AS3000 electrical wiring standards.
12 installation diagram Kelvinator heat pump hot water system
off peak wiring configuration
continuous
supply input
storage tank
storage tank
heater output
heater output
sensor cable plugs in here
under heat pump (drain assembly
viewed from back of unit) –
discharge condensation drain
hose to a suitable location
refer to the electrical section for more detail
on wiring the heat pump
refer to local electrical
requirements to
off peak
ascertain whether
supply input
isolation switch is
required
uncontrolled
hot water outlet
(kitchen, laundry)
25mm
diameter
conduit
outlet
25mm
diameter
conduit
inlet
cold
inlet cold water
expansion
pressure limiting
control valve
valve (600kPa)
(700kPa) may be
isolating
may be required
and non required refer to
if pressure
return local plumbing
exceeds 600kPa
valve guidelines
tempered
(50°C)
hot water
outlet
(bathroom
tempering
valve
20mm
diame
condu