Dts-Hd Speaker Re-Map; Trigger Outputs; Sw Version; Update Via Usb - Cambridge Audio CXR120 Owner's Manual

HDMI output setup cont.

DTS-HD speaker re-map

When playing back a DTS-HD track the CXR can electronically reposition
your speakers to match the setup used in the original recording studio. This
is done automatically in most cases, but for 7.1 setups you will need to
choose either option 1 or 5 – whichever most closely resembles your actual
speaker layout.
Left (30°)
LFE
Left Surround (110°)
Left Surround Rear
(150°)
Left (30°)
LFE
Left Surround Side
(90°)
Left Surround Rear
(150°)

Trigger outputs

The options are:
button on the remote control.

SW version

All 4 software version numbers need to be stated when contacting Cambridge
Audio customer support.

Update via USB

The CXR software can be updated from the front panel USB socket, which
would normally only be required by a service department or where a network
is not available. Normally user updates will be via a network connection.

Save current settings

Saves settings to internal memory. If the current settings have not been
saved, it is advisable to save the current settings before a software update
is performed.
Load saved settings
Loads the stored settings.

Factory reset

After a factory reset any saved settings can be restored if desired.
16
Center
Right (30°)
Right Surround
(110°)
Right Surround Rear
(150°)
Center
Right (30°)
Right Surround
Side (90°)
Right Surround Rear
(150°)

Network software update

The CXR can be updated via the StreamMagic module connected to the
internet. Updates of the StreamMagic module itself can only be started from
the Cambridge Connect app or the Web administration interface.
Note: A full update can take over 45 minutes to complete.

Web administration interface

This interface allows the user to:
- Customise the name displayed in the Players list in the Cambridge Connect
app and in the Spotify Connect device list.
- Setup the wireless network connection.

Wired connection

CXR Setup Menu
Speaker Setup Connection Information
Input Setup Network Selection
Zone 2 Settings IP Adress
Network Setup Subnet Mask
General Settings Gateway
HDMI Output Setup DNS1
Advanced Setup
Use a web browser on the same network to connect to the CXR IP address,
eg http://192.168.0.127/

Wireless connection

Plug in the supplied wireless antenna to the USB socket on the rear of the
CXR.
Go to your computer/tablet and click on the Wi-Fi/network logo and select
CXR.
Use a web browser on your device to connect to http://10.10.10.10/
Ethernet
192.168.0.127
0.0.0.0
0.0.0.0
0.0.0.0
Next Page