Philips GC7600 series Directions For Use Manual page 10

ENGLISH
10
4239_000_8626_5_DFU-Luxury_A5_v2.indd 10
Energy saving
ECO mode
By using the ECO mode (reduced amount of steam), you can save energy
without compromising on the ironing result.
1 To activate the ECO mode, press the ECO button. The green ECO
light goes on.
2 To deactivate the ECO mode, press the ECO button again.
The green ECO light goes out.
For the best results on tough fabrics, you can use the TURBO mode.
1 Press and hold the on/off button for 2 seconds until the light turns
white.
2 To deactivate the TURBO mode, press and hold the on/off button for
2 seconds again until the light turns blue.
Safety auto-off (specific types only)
The safety auto-off function automatically switches off the appliance if it has
not been used for 5 minutes, to save energy.
IMPORTANT: Replacing the ANTI-CALC cartridge
ANTI-CALC replacement light
It is very important that you replace the ANTI-CALC cartridge when the
ANTI-CALC cartridge replacement light starts flashing and the appliance
starts beeping.
Note: The cartridge lasts 1-3 months on average, but this depends on the
hardness of the water you use and on how many hours you iron.
- The ANTI-CALC replacement light starts flashing and the appliance
starts beeping to indicate that the ANTI-CALC cartridge needs to be
replaced.
- You can still continue steam ironing for 15-30 min. (depending on
the hardness of the water used) when the ANTI-CALC replacement
light flashes and the appliance beeps. However, the steam output will
diminish and ultimately the steam generator stops producing steam to
prevent scale build-up that would permanently damage your appliance.
- To let the appliance produce steam again, you have to replace the
ANTI-CALC cartridge. If you do not want to replace the ANTI-CALC
cartridge, you have to use demineralised water or descaled water from
the IronCare. In that case, you need to leave the exhausted cartridge in
the compartment.
31/03/15 10:29