ONE dupray Instruction Manual page 10

CONNECTING THE STEAM HOSE
Connect the steam hose by inserting the steam hose connector in the steam hose connection outlet and
press firmly. Make sure it cannot be pushed in any further and that the locking pin on the flap is in place.
IMPORTANT:
Make sure the locking pin on the flap is inserted in the hose connection.
ADJUSTING THE STEAM PRESSURE
Adjust the desired steam pressure using the steam pressure regulator wheel located on the hose handle,
from minimum (-) to maximum (+). Connect the accessory that you want to use to the steam hose.
To release steam, simply press the steam release trigger on the hose handle.
REFILLING WITH WATER
When steam runs out or if the low water indicator (8) comes on during usage and you would like to continue using the steam cleaner, you will
need to follow these steps:
Turn the main dial
to the OFF position (this shuts
off the power to the heating
element).
IMPORTANT:
Do not overfill. Leave space for steam !
WARNING:
If all steam pressure has not been released, steam may escape from the cap when opening, use caution.
Hold the steam release trigger on
the handle until all the steam has
evacuated the steam cleaner (the
pressure gauge must be at zero).
COOL DOWN
FOR 10 MINUTES
When there is no more steam,
wait 10 minutes for the boiler
to cool down.
Open the boiler cap slowly and refill
1.2L (40 oz)
the steam cleaner with
water. Refasten the boiler cap, turn the
main dial to the position and wait for
the SteamReady™ indicator to turn on.
of