Cleaning The Doors - Indesit ID6IVS2/UK Operating Instructions Manual

Care and Cleaning
Control Panel:
Wipe with a damp cloth and polish with a dry cloth.
Stainless trims
Regularly wipe with a clean, damp cloth and polish with
a clean dry cloth.
Grill Door:
Wipe over the grill door decorative outer panel; with a
cloth wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft clean
cloth.
Do not use scouring pads or abrasive powder which
may scratch the surface.
Ensure that the glass panel (where fitted) is not
subjected to any sharp mechanical blows.
Grill:
Remove the grill pan and the wire grid food support, it
is best to wash these items immediately after each use
to prevent stains from being burnt on when used again.
Wipe out the Grill compartment, use a fine steel wool soap
pad to remove stubborn stains from the compartment.
Main oven:
1. Glass Door - open the oven door fully.The glass
panel may now be cleaned. Stubborn stains can be
removed by using a fine steel wool soap pad.Do not
use scouring pads, or abrasive powder, which will
scratch the glass. Ensure that the glass panel is not
subjected to any sharp mechanical blows. For slight
soiling the inner glass panel may be cleaned, while
still warm. For removing stubborn stains see "Care
and Cleaning" chapter.
2. Remove the rod shelves and meat pan. Use a fine
steel wool soap pad to remove stubborn stains from
the rod shelves,meat pan and the floor of the oven.
Refer to the instructions in "Care and Cleaning" chap-
ter, for cleaning the shelf supports. Do not use aerosol
cleaners on this oven as they could adversely affect
the fan motor unit, and cannot be wiped off the fan
blade.
Replacement oven lamp:
WARNING: To avoid electric shocks - please ensure
that the electricity supply to the appliance is switched
off and the appliance is fully cold, before removing
the lamp lens.
Open the oven door and remove the rod shelves. Using
a suitable cloth to protect the fingers grip the light glass
dome, unscrew anti-clockwise and lift. Reach into the
aperture and unscrew the lamp anti-clockwise. Fit
replacement lamp (25W 300°C rated SES), refit dome.
Wall-mounted splash panel:
A wall-mounted splash panel is available as an optional
extra from our Parts Department (see Key Contacts,
back page).
Care must be taken that rating label edges are not lifted
during cleaning and furthermore that the lettering is not
blurred or removed. For details of your nearest Service
Centre please see the separate service leaflet. If you have
any queries regarding service or spares, our Parts and
Service Division will be pleased to advise.
See Key Contacts, back page, for details.
Take particular care not to damage the inner surface
of the door inner glass that is coated with a heat
reflective layer.Do not use scouring pads, or abrasive
powder, which will scratch the glass. Ensure that the
glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel
wool pad. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door. After cleaning, rinse and dry with a soft cloth.

CLEANING THE DOORS

SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down
doors,except take care to support the weight of the
inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws se-
curing the glass panel so that the securing brackets
can be turned.There is no need to remove the screws
completely.
2. Turn the brackets so that the glass can be removed
and cleaned at the sink (Fig. 1.)
3. The inside of the outer door glass can now be cleaned
while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT
THE INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1.Turn the two securing bra-
ckets back to their original
position to retain the glass and
tighten the screws. (Fig. 2.)
GB
23