6. Secure motor lock lever in place on the brake release shaft with existing mounting
screw.
7. Install the drive wheel from the wheelchair. Refer to Removing/Installing Drive
Wheels on page 138.
8. If necessary, install the 22NF battery box tray. Refer to Removing/Installing Battery
Boxes on page 121.
9. Plug the wiring harness connector into the motor.
10. Secure the wiring harness connector to the motor with the existing two mounting
screws.
11. Install the battery boxes. Refer to Removing/Installing Battery Boxes on page 121.
Brake Release Shaft
Motor
Suspension Arm
Wiring Harness
Connector
FIGURE 14.14 Removing/Installing the Motor - Standard Gearless/Brushless Motor Before
Part No. 1104849
Guide Bushing
Mounting
Screws
Mounting
Screws
1/26/04
153
SECTION 14—WHEELS/MOTORS
Alignment Pin
Washers
3G Storm Series® Wheelchairs
Washer
Motor Lock
Lever
Adjustment
Screw