Invacare Arrow RWD Service Manual page 110

SECTION 12—BATTERIES
Connecting
NOTE: Perform this procedure on one battery and battery box at a time. Repeat procedure for other
battery box.
1. Position battery box top next to battery box bottom as shown in FIGURE 12.4.
2. Peel back battery clamp covers to expose battery clamp on each battery cable as
follows:
A. RED battery clamp cover from RED battery cable.
B. BLACK battery clamp cover from BLACK battery cable.
3. Connect NEGATIVE
POSITIVE battery cable clamp to POSITIVE (+) battery post (FIGURE 12.4).
P
4. Secure the battery cable clamp(s) to the battery post(s) with provided hex screws and
nuts. Securely tighten.
5. Verify battery cable clamps(s) are correctly installed and securely tightened.
6. Reposition battery clamp covers over battery post(s).
7. Install the battery box top(s).
8. Install the battery box(es) into the wheelchair. Refer to Removing/Installing Battery
Boxes on page 121.
NOTE: New Battery(ies) MUST be fully charged before using, otherwise the life of the battery(ies)
will be reduced.
9. If necessary, charge the battery(ies). Refer to Charging Batteries on page 117.
3G Storm Series® Wheelchairs
battery cable clamp to NEGATIVE(-) battery post and connect
N
110
Part No. 1104849