Care And Maintenance; Changing The Light Bulb - Frigidaire FTE5200SBRE Operating Instructions Manual

CARE AND MAINTENANCE

CHANGING THE LIGHT BULB

Refrigerator Light
1. Switch off the power at the power point and remove
the cord by pulling the plug.
2. Carefully unclip the light cover as shown.
pull
3. Unscrew the light bulb and replace it with a new bulb
of the same type and wattage. If, when you remove the
light bulb the small rubber "O" ring comes out with the
bulb, fi t the "O" ring over the new bulb and screw the
bulb into the socket (see diagram at bottom of page).
Never insert your fi nger into the light
bulb socket to check for the presence of
the "O" ring.
4. Replace the light cover by hooking the lugs into the
slots and pressing up until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalised, before turning the refrigerator on
at the power point.
Freezer light (where fi tted)
1. Switch off the power at the
power point and remove the
cord by pulling the plug.
2. Carefully unclip the light cover
by pulling the light cover tab at
the rear, towards you.
3. Unscrew the light bulb and
replace it with a new one of the same type and
wattage. If, when you remove the light bulb the small
rubber "O" ring comes out with the bulb, fi t the "O" ring
over the new bulb and screw bulb into the socket (see
diagram at bottom of page).
Never insert your fi nger into the light bulb socket to
check for the presence of the "O" ring.
4. Replace the light cover by hooking the light cover lugs
into the front of the housing and pressing the rear of the
cover up until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalised before turning the refrigerator on
at the power point.
TIPS & INFORMATION
Ensure the 'O' ring is in place before replacing the bulb.
Light bulb "O" ring Light socket
CLEANING THE REFRIGERATOR
WARNING
BEFORE CLEANING: Turn the refrigerator off at the power
point and unplug the cord to prevent any chance of
electrocuting yourself.
• Doors and exterior (white & pacifi c silver)
You should only clean the doors with lukewarm soapy
water and a soft cloth.
• Stainless Steel
Your stainless steel refrigerator is manufactured from
mark-resistant stainless steel. This stainless steel has
a special advanced protective coating that eases
the removal of marks such as fi ngerprints and water
spots. To keep its appearance, clean it regularly with
lukewarm soapy water and a soft cloth.
CAUTION
Never use stainless steel cleaners, abrasive pads or other
cleaners that will scratch the surface. Damage to the
appliance after delivery is not covered by your warranty.
• Interior
Clean the inside of your refrigerator regularly with a
soft cloth, unscented mild soap and lukewarm water.
Thoroughly dry all surfaces and removable parts and
avoid getting water on the controls. Replace removable
parts, plug power cord in and switch the power on
before returning the food.
• Door seals
Always keep door seals clean by washing them with
a mild detergent and warm water, followed by a
thorough drying. Sticky food and drink can cause seals
to stick to the cabinet and tear when you open the
door.
CAUTION
Never use hot water, solvents, commercial kitchen cleaners,
aerosol cleaners, metal polishes, caustic or abrasive
cleaners, or scourers to clean your refrigerator. Many
commercially available cleaning products and detergents
contain solvents that will damage your refrigerator.
Use only a soft cloth with an unscented mild soap and
lukewarm water.
If your refrigerator has telescopic extension slides, simply
wipe them with a damp cloth to clean them and never
immerse them in water.
CARE &
11
MAINTENANCE