Fixing the Installation Plate
Before fixing the installation plate to the wall or window frame, you must
determine the position of the 65mm hole through which the cable, pipe and
hose pass to connect the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected from the:
Right
Left
Underside (right)
Rear (right or left)
1
Determine the position of the pipe and drain hose hole as seen in the picture
and drill the hole with an inner diameter of 65mm so that it slants slightly
downwards.
2
If you fix the indoor unit to a...
Wall
Window frame
3
Fix the installation plate to the wall giving attention to the weight of the
indoor unit.
If you mount the plate to a concrete wall with anchor bolts, the anchor
bolts must not project more than 20mm.
4
Determine the positions of the wooden uprights to be attached to the
window frame.
5
Attach the wooden uprights to the window frame giving attention to the
weight of the indoor unit.
6
Attach the installation plate to the wooden uprights using tapping screws as
seen in the picture.
Purging the Indoor Unit
Upon delivery, there may be inert gas inside the indoor unit. Purge the gas
from the indoor unit before connecting the assembly pipe.
Unscrew the caps at the end of each pipe.
Result:
All inert gas exhausts from the indoor unit.
To prevent dirt or foreign substances from getting into the pipes during
installation, do NOT remove the caps completely until you are ready to
connect the pipes.
Follow step(s)...
3.
4 to 6.
I
A
NSTALLING THE
IR CONDTIONER
(Unit : mm)
022/028/036
Pipe hole
(Ø65mm)
120
(Unit : mm)
056/071
Pipe hole
(Ø65mm)
140
68
68
7
E-