Remote Control - VACBOT S200 User Manual

4. Collided
When this function is activated, the robot will slow down its moving speed in order not to collide with any
objects when cleaning. This function is ideal on cluttered space.
5. Vacuum Motor
The robot cannot perform the cleaning process without the activation of the vacuum motor function.
6. Home
When this function is activated, the robot will start searching for the Home Base to charge itself.

19 REMOTE CONTROL

All function buttons on the vacuum and floor mopping robot's panel are available on the remote control.
There are some additional unique buttons on the remote control shown below.
Power Button:
Press this button to activate or to shut down the robot.
Start/Stop Button:
Press this button to activate the vacuum and floor mopping robot to perform or to stop the cleaning
process.
Direction Buttons:
Left/Right/Reverse/Forward buttons for users to control the robot movement manually.
Home Button:
This function interrupts the leaning cycle and commands the robot to go back to the Home Base.
Mode Button:
Manually sets up the cleaning mode of the vacuum and floor mopping robot. Each press will command the
vacuum and floor mopping robot to change its cleaning mode in the sequence of the following patterns.
Users may also find the current pattern code on the vacuum and floor mopping robot's display panel.
1. Spot Spiral
2. Ultrasonic Collision Obstacle Detection
3. Wall Following
4. Zig-Zag
5. Polygonal Spiral
6. Automatic
15