Motion Zone Setup - Panasonic SP-DR04 Instruction Manual

3-4-4. Motion Zone Setup

◀ ▲ ▶ ▼
Select MOTION ZONE using the mouse or the control button ( ) on the remote control and
select either PARTIAL ZONE or FULL ZONE using the mouse control. The default value is FULL ZONE.
If FULL ZONE is selected, the motion setting screen is not displayed. Only set the level of sensitivity for
MOTION SENSITIVITY.
FULL ZONE: The motion sensor is active on the whole screen.
PARTIAL ZONE: The motion sensor is active in the set detection frame.
◀ ▲ ▶ ▼
Select the sensor detection position using the mouse or the control button ( ) on the remote
control. Then the color of the position which is selected will be changed. And the press the right button of
the mouse or SEL button of the remote control. Press OK button of the SETUP menu to save the setting
value.
Figure 3.4.5. Motion Zone selection screen
28