Table of Contents
Advertisement
TROUBLESHOOTING GUIDE continued
TROUBLE
Remote control does
not work
Autosearch can't find the
desired source
No on-screen display (OSD)
OSD hard to read against
video image
OSD blanks video picture
"Digital Error" message on
display
Some C 1 functions
don't work
Built-in screen doesn't show
video program
Difficult to read status mes-
sages on built-in screen
Note: Additional information can be found by checking the Product FAQs (frequently-asked
questions) and tech bulletins on our Web site, www.parasound.com/halo
PROBABLE CAUSE
Remote beam reaching both built-in
and remote infrared sensor at once
Infrared beam from remote
cannot reach sensor
Battery problem
Source component is turned off
Player is stopped
Wrong signal types
Video monitor off
OSD set for wrong connection
Video monitor disconnected
Video monitor is connected to the
"No OSD" jack on C 1
"Superimpose" set to "On"
"Superimpose" set to "Off"
Faulty input signal
Control microprocessor is
latched, or "locked up"
No composite video signal
available
Display screen too dim
REMEDY
Change setup so beam reaches only
one sensor
Clear any obstructions
Make sure batteries are fresh and are
inserted correctly
Turn source component on
Make sure player is in "Play" or "Pause
Check connections and the "Source setup"
menu to be sure desired source receives digi-
tal audio, composite video, or S-video signals
Turn video monitor on
In "Display Setup" set "OSD Output" to
"Both"
Reconnect video monitor
Move cable to "OSD" jack
Set "Superimpose" in "Display setup" to "Off"
Set "Superimpose" in "Display setup" to "On"
If message persists more than a few seconds,
change satellite channel, DVD, or CD; check
source component; check satellite dish
Turn the C 1 off by its front-panel switch, then
by its rear-panel switch, wait about one
minute, and turn it back on again
Attach a cable from the composite video out-
put of each source to the corresponding C 1
composite video input jack
Press the Dim button to increase brightness
View screen closer to on-axis
57
Advertisement
Table of Contents
