3. NEEDLE BAR HEIGHT
(ALL MODELS)
Check :
Adjustment :
Attention :
1. Take out bobbin case and shuttle race cap.
2. Select zigzag and max , width stitch.
3. Rotate hand wheel until needle is full down in
right position.
4. Then , slowly raise needle bar to (a) position ,
the distance shall be 1 mm.
1. Open face cover.
2. Loosen needle bar clamp screw (A).
3. Slightly move needle bar (B) up or down until
location is 1 mm.
4. Tighten clamp screw (Torque 15kg-cm).
1. After completing adjustment, make sure that
needle is parallel to shuttle.
B
A
L
shuttle hook
4
R
a