Table of Contents
Advertisement
Available languages
Available languages
Installation/Mounting
Warning: Make sure that an all-pole switch is connected to the incoming mains lead.
Warning: Make sure that the all-pole switch is turned off before beginning installation.
Note: Have someone assist you during installation.
1. Open the box and remove the fan and its parts. Check that all the parts are present.
2. Screw the ceiling rose (9) onto the motor
housing (8), using the included screws and
washers (shown by the arrows) that are
pre-mounted to the motor housing.
3. Flip the fan over so that the lamp housing is
facing upwards. Screw the fan blade brackets
(6) onto the motor's drive disc, in the following
order: Rubber washer (pre-mounted), blade
bracket, washer and screw. Use the screws
and washers that are pre-mounted onto
the lamp housing (shown by the arrows).
4. Screw the fan blades (7) onto the fan brackets.
The fan blade's screws and washers and pull-
chains (1 and 4) come in a plastic bag.
5. Screw the ceiling mounting bracket (12) into
the ceiling , making sure that the incoming
mains lead enters through the bracket's
centre hole. Use appropriate screws and
flat/spring washers for fastening. Make sure
that the mounting surface and screws have
sufficient weight bearing capacity for the weight
of the fan before installing the ceiling mounting
bracket. Make sure there are no hidden
electrical cables or pipes in the ceiling before
drilling any mounting holes.
6. Connect the electrical wires from the incoming
mains conduit to the mounting bracket's
terminal block (10). Connect the blue wire to
the N terminal the brown wire to the L terminal
and the yellow/green wire to the
terminal.
5
9
8
6
7
Advertisement
Table of Contents
