Introduction; Initial Start-Up; Your System Is Preset At The Factory; General Description - Viessmann Vitodens 100 Installation And Service Instructions Manual

Initial start-up

The initial start-up and matching of
the control unit to local conditions and
the structural characteristics of the
building must be carried out by your
heating contractor.

Your system is preset at the factory

Your boiler will provide both heating
and hot water providing a cylinder is
installed.
Your heating system is ready for use.
You may change the factory settings
in accordance with personal require-
ments.
Note
All data is saved in case of power fail-
ure.

General Description

The Vitodens 100 is a fully automatic,
wall mounted, fan assisted balanced,
gas condensing boiler for use with
natural gas (G20) at 20mbar (8 in.wg)
for use on sealed or open vented sys-
tems.
The Vitodens 100 is certified to com-
ply with the requirements of the rele-
vant European Directives (90/396/
EEC, 73/23 EEC and 92/42/EEC) for
use in Great Britain and Ireland with
gas category I2H (G20 with a gov-
erned gas supply at 20 mbar (8 in.wg)
inlet pressure).
The appliance classification is either
C or C depending upon whether
13x 33x
a horizontal or vertical flue terminal is
used.
The 2 units provide central heating at
outputs between 8.0 kW to 18.0 kW/
24.0 kW. If required, the central heat-
ing heat output can be range rated to
suit the system requirements.
Heat output is automatically con-
trolled according to demand.

Introduction

5