English HDS 698 C CONTENTS ENVIRONMENTAL PROTECTION Maintenance tasks Environmental protection Items used when working, such as Cleaning strainer in water Prior to initial startup, operating fuel, oil, cleaning agent and connection manual and safety instructions Overview contaminated maintenance Cleaning strainer in low water...
English HDS 698 C OVERVIEW COMMISSIONING Filling with scale inhibitor Filling with cleaning agent Fig. 1 Fig. 5 1 Swivel caster with parking brake (sample pack included with scope of * Only use KÄRCHER products. 2 Connection for high-pressure hose delivery) –...
English HDS 698 C Water connection Mains connection OPERATION Setting cleaning temperature Refer to technical data and rating Set selector switch (1) to desired For connected loads, refer to plate for connected loads. temperature Technical Data. * Never operate unit with fuel tank...
English HDS 698 C Fig. 10 Working with high-pressure Recommended cleaning method Operation with steam Set cleaning-agent concentration as nozzle Loosen up dirt: specified by manufacturer Spray angle is crucial to efficiency of Spray on cleaning agent sparingly 0 =Working without cleaning agent high-pressure jet.
English HDS 698 C EACH TIME AFTER USAGE DISCONTINUATION OF USAGE MAINTENANCE Maintenance intervals Following operation with cleaning agent In the event of lengthy periods of Once a week – Set cleaning-agent regulator to "0" non-use or if frost-free storage is not –...
English HDS 698 C – Check connections and lines MAINTENANCE TASKS Changing oil FAULTS Pressure set to MIN Fig. 18 – Set pressure to MAX – Provide a collecting container for READY FOR OPERATION approx. 1 litres of oil indicator lamp off...
English HDS 698 C Burner not ignited If fault cannot be rectified, have becoming dirty and requires regular GENERAL INSTRUCTIONS Fuel tank empty unit checked by After-Sales cleaning. – Fill up Service. * Motor protection switch Safety features Lack of water...
English HDS 698 C Working temperature TECHNICAL DATA -Hot water max. 90 C -Steam operation mode 98-155 C Mains connection 200 V Cleaning agent intake 0-12 l/h 3~50 Hz Connected power 3,6 kW Burner capacity 40 kW Fuse protection (slow response)