Jumper Settings - Airwell PNX DCI Nordic Service Manual

11.11 On Unit Controls and Indicators
11.11.1 Indoor Unit Controller Controls and Indicators.
STAND BY INDICATOR
OPERATION INDICATOR
TIMER INDICATOR
FILTER INDICATOR
COOLING INDICATOR
HEATING INDICATOR
Mode SWITCH
(COOL/HEAT/OFF)
RESET / FILTER SWITCH
11.11.2 Outdoor Unit Controller Indicators
Unit has three LED
SB LED is ON when power is ON (230 VAC, even when no communication).
STATUS LED is ON when COMP is ON, and Blinks according to diagnostics mode definitions when either fault or protection
occurs.
FAULT LED Blinks according to diagnostics mode definitions when either fault or protection occurs.
11.12

Jumper Settings

11.12.1 Indoor Unit Controller
0 = Open Jumper (disconnect jumper).
1 = Close Jumper (connect jumper).
Self test Jumper – J1
OPERATION
SELF-TEST
NORMAL
Compensation Jumper –J2
Model
Wall Mounted (PNX)
Family selection Jumper – J3, J4 and J5
Family
Reserved
Reserved
Reserved
Wall Mounted (PNX)
SM PNXDCI 1-A.1 GB
Lights up when the Air Conditioner is connected to power and ready toreceive the R/C
commands
Lights up during operation.
Blinks for 300 msec., to announce that a R/C infrared signal has been received and
stored.
Blinks continuously during protections (according to the relevant spec section).
Lights up during Timer and Sleep operation.
Lights up when Air Filter needs to be cleaned.
Lights up when system is switched to Cool Mode by using the Mode Switch on the unit.
Lights up when system is switched Heat Mode by using the Mode Switch on the unit.
Every short pressing , the next operation mode is selected, in this order:
SB → Cool Mode → Heat Mode → SB →
In long pressing system enters diagnostic mode.
For short pressing:
When Filter LED is on - turn off the FILTER INDICATOR after a clean filter has been
reinstalled.
When Filter LED is off able/disable the buzzer announcer, if selected.
J1
1
0
J2 (Default) Compensation
0 Activated
J5 J4 J3
0 0 0
0 0 1
0 1 1
0 1 1
CONTENTS
CONTROL SYSTEM
11-9