Parts Identification; Assembly - Eckman EKELV2 Instruction Manual

Parts Identification

7
4
5
1. Crankcase
2. On/off switch
3. Vacuum/blower selection lever
4. Median vacuum/blower tube
5. Wheeled vacuum/blower tube
6. Collection bag
7. Handle
8. Shoulder belt

Assembly

Warning!
The vacuum/blower must not be used or switched on until it has been fully assembled.
Assembly (Photo 1 & Photo 2)
Connect the two sections of tubes together using 1 x 50mm long screw provided and a Philips screwdriver.
photo 1). Connect the whole vacuum/blower pipe into the outlet using the provided two screws(normal longer screw +
one-way screw)by Slotted screwdriver (see photo 2) on both sides. Ensure the whole pipe is fully connected.
Photo 1
Fitting the collection bag (Photo3 & Photo4 &Photo5)
2
1
3
6
Photo 2
6
8
(see