Technical Specifications - Eckman EKELV2 Instruction Manual

g) Disconnect the appliance from the power supply when checking the appliance, in the event of blockages or
if it vibrates abnormally.
h) Do not rush. Remain in a stable and balanced position at all times.
i) Always be sure of your steps on slopes. Strap the appliance to yourself using the accessory designed for
this purpose.
j) Walk; never run when holding the appliance.
Recommendations
k) It is recommended that you slightly dampen dusty surfaces or that you use a mist blower.
l) It is recommended that you use the intake/outlet tube at its maximum length to be able to reach the ground
with the air flow.
m) It is recommended that you operate the appliance only at reasonable times, not too early in the morning
and not too late in the evening, which may disturb neighbours. Keep to the times set by local regulations.
INSTRUCTIONS TO FOLLOW AFTER USE
a) Disconnect the appliance from the power supply after use.
b) Clean the appliance adequately following the precautions described in chapter 6.

Technical Specifications

TECHNICAL SPECIFICATIONS
Voltage rating
Type of power supply and Frequency rating
Power rating
No load speed
Air volume(vacuum)
Air Speed(blowing)
Electrical protection class:
Appliance protection against penetration by solids and liquids
Collector capacity
Net/Gross Weight
SPL measurement uncertainty
SPL (Sound power level)
Vibration level
Measurement uncertainty
Mulching Ratio
The total noise and vibration levels declared were measured in accordance with a test method from
directive 2006 / 42 / EC.
230-240 V
50 Hz
3000
W
15,000/min
13.2m³/min
270km/h
Class II
IP 20
35 L
3.0/3.68 kg(with 10m BS cord)
kPa =3dB
102 dB (A);
2
4.813 m / s
K=1.5m / s 2
10:1
5