Routing The Cables - Partner Tech International RP-800 User Manual

Routing the Cables

After you have connected the power cord and other interface cables
to the printer, you may need to route these cables properly for safety
concerns.
1
Pass the power cord through the cable collector at the rear side of
the printer.
2
Repeat
not pinched or tangled.
NOTE: Always keep a safe distance (approximately 30 mm)
between the cables and the wall or other objects behind the
printer.
Routing the Cables
14
24V
Step 1
to route other cables. Make sure all the cables are
Cable
collector
RS232