Removal Of Stand Brackets; Replacement Of The Plasma Panel - Panasonic TH-37PW7BX Service Manual

b. Release all cables from the clamper on the bracket of the
front frame.
c. For leaving the plasma panel from the front frame, pull the
bottom of the front frame to forward, lift, and remove.

7.17. Removal of stand brackets

a. Remove the plasma panel section from the servicing stand
and lay on a table (covered), with the plasma panel surface
facing downward.
Spread a soft cloth for protection, to prevent panel surface from
scratching.
b. Remove the stand bracket (left, right) fastening screws (×4
each) and remove the stand brackets (left, right).
7.18. Replacement of the plasma
panel
a. Place the new plasma panel (finished) on the flat surface of
the table (covered by a soft cloth), with the plasma panel
surface facing downward.
b. Fit the stand brackets (left, right.) fast 4 screws each on the
new plasma panel.
c. Place the plasma panel section on the servicing stand.
d. Attach the front frame each P.C.Board and so on, to the new
plasma panel.
* When fitting the front frame, be careful not to allow any
debris, dust or handling residues to remain between the
front glass and plasma panel.
15
TH-37PW7BX